Box of 5 pairs of 2 P1E1 plates for tracking on 1 axis. Accessories for E1 gauge.
Box of 5 triplets of 3 P2E1 plates for 2-axis tracking. Accessories for E1 gauge.
Protection with anti-UV filter for G1 gauges fixed outside (delivered with impact anchors)
Glue rapid hardening in twin syringe
Kit for mechanical fixing to the structure wherever the condition of its surface does not allow the use of self-adhesive tabs (1 drill + 1 screwdriver + 40 impact anchors)
Impact anchors pack for mechanical fixing to the structure wherever the condition of its surface does not allow the use of self-adhesive tabs (pack of 50 units)
For measuring the variation in a crack in a vertical or horizontal internal angle (with self-adhesive tabs and 1 impact anchor).
To install the G3 gauge if surface is irregular, damaged, damp or of poor quality. Delivered with impact anchors.
G3 Protective cover in IP65 aluminium. Fourni avec visserie. Delivered with impact anchors.
G3 Protective cover in thermoformed plastic. Fourni avec visserie. Delivered with impact anchors.
For graphic recording of structural yielding. To be mounted on the G3 Gauge. This new device records the maximum and minimum distortion on the graph.
For fixing the G5 gauge with an angle bar when the gauge can not be attached to the cross-section of the retaining wall.
G5 Protective plastic casing if the G5 gauge is exposed to the weather.
G5 Protective cover in IP65 aluminium. Delivered with impact anchors.
Use of a ball joint for G4 gauge is advised if the distortion is significant.
G4 Protective plastic casing if the G4 gauge is exposed to the weather. Delivered with impact anchors.
Protection with anti-UV filter for G6 gauges fixed outside. Delivered with impact anchors.
Pack of a set of 2 baseplates for fixing the 3Dim. gauge.
Additional extensions in treated aluminium, 0.50 m long, which are screwed into position between 2 graduated rods.
